TIG SOUND DC 2341/T

TIG SOUND 2341/T DC is a three-phase (MULTI-VOLTAGE) inverter power source for TIG and MMA-SMAW use, not including AWS6010 cellulosic electrodes, designed for medium production batches. The machine may work with pulsed arc, for use also on thin workpieces where heat transfer must be minimal.

The machine may be connected to an optional cooling unit (art. 1341) for water-cooled torches. The power source is set up for remote control via the foot control (art. 193), remote control unit (art. 187) or up-down control on the torch. Its tunnel design allows exceptional cooling efficiency, keeping those components that suffer in dusty environments, such as electronic circuits, out of the cooling flow.

In TIG mode, the arc is started either in high voltage/high frequency or by contact with the Cebora lift system. It is also possible to save up to 9 welding programs in memory. Art. 360 is also designed for use with Plasma Welding Console (art. 476.50). The power source can be powered by motor generators.

Complies with EN 61000-3-12.

Comparison table of the different power source features

= standard           = optional

Feature	Power source part number
	264	265	360 362	364	365	363 373	369 370 371
Max. pulse frequency 2.5 kHz
Max. pulse frequency 500 Hz
High Frequency ignition
"Lift by Cebora" ignition
Spot welding mode
2 times / 4 times
3 level mode
2 level and 4 time mode
Minimum current in AC TIG 5 A	n.a.	n.a.	n.a.			n.a.
Max. AC frequency 150 Hz	n.a.	n.a.	n.a.			n.a.
Crater current adjustment
Wave form selection	n.a.	n.a.	n.a.			n.a.
AC horizontal balance	n.a.	n.a.	n.a.			n.a.
AC vertical balance (AAd)	n.a.	n.a.	n.a.			n.a.
Remote control
Synergic parameters
Slope up adjustment
Slope down adjustment
Pre-gas adjustment
Post-gas adjustment
Load controlled fan
Job mode
Interface for cooling unit
Ready for automatic Plasma Welding console
Ready for manual Plasma Welding console
Interface for TIG Hot / Cold Wire feeder
Ready for interfacing with robot via either analog or fieldbus
TIG MIX process	n.a.	n.a.	n.a.			n.a.
EVO Start (ESt) adjustment
HF ignition by "EVO Lift" (ELF)
Panel locking
Digital gas control
Quality Control function
DC MMA welding
AC MMA welding						n.a.
"Arc Force" function in MMA welding
"Hot Start" current
USB interface
RS-232 interface
Possibility to update the software
Conformity with EN61000-3-12 (PFC)
Suitable for use in environments with increased hazard of electric shock
IP23S protection class
The power source can be powered by motor generators of adequate power
Single phase power supply 230V +15% / -20%
Three-phase power supply 400V ±10%
Multivoltage single phase power supply 115 - 230V +15% / -20%
Multivoltage three-phase power supply 208-220-230-400-440V ±10%